You are watching: Snap-on compression tester rev h
I just tested the compression on mine "05 800 Gade with WOT and got Cold/Hot: PTO = 158/150 MAG = 155/155 The mag side cylinder to be rebult in ~ 2000 mile under warranty so the is the factor for the far better numbers...but my biggest concern is mine compression tester shows up to start at 15....is this normal? have the right to someone look at your tester and also see where the needle starts? If this isn"t common then have the right to I assume the I have to subtract 15 off of my numbers? I additionally tested mine bros rev and got numbers above 150....Any opinions?
crank up the wait comp and see what that gage has on it climate hook up this one to watch what you acquire for a reading, that is what ns did and no the gage must read zero
Dan PesonenIf the ain"t broke, modify something till the is.....Frankensled originalFrankensled V2.05.5" van box, 11.5" l sled, What"s the difficulty Officer? it fit"s good with the tailgate down!!!
How carry out I hook it approximately the wait compressor? room you saying to unscrew the gauge from mine compressor and also screw this right into it? If ns am counting right my guage is readin 15lbs...there is just one much more tick before the 25lb tick.....so the would mean mine is ~ above the 15lb mark...
See more: The Pros And Cons Of Hillary And Trump And Hillary Clinton, The Electoral College: Top 3 Pros And Cons
the needle can/did move on the post,,so as soon as you use it,,facter that in,,or shot another guagei checked my sleds cold through a MAC devices comp guage,and it checked out 100psi in 1 pull climate after 5 an ext it just went come 125 both,,,then hr later on i supplied a SNAPON guage,and it started 35-40psi,1st pull climate 80,till it gained to 155psi every side,,which i used that snappy guage critical year/same reading/borrowed them native auto machineshop accross the street//the owner has actually the better guage